The selection, design, and location of piping supports is an essential part in the study of any industrial process installation. Typically, piping is supported at regular intervals on steel supports embedded in concrete foundations or directly on steel structures. The distance between supports is the span. The allowable spans between supports of horizontal lines are […]
Within the family of non-metallic pipes there are different types used in the industry: GRP (Reinforced Fiberglass), PVC, PP (Polypropylene), HDPE (High Density Polyethylene) among others. This type of systems are usually used in industrial plants in general, petrochemical plants, water treatment plants, sea water desalination plants and in power generation plants. One of the […]
Any pressure vessels specialist could face a situation when it is necessary, due to several reasons (high criticality, toxicity, process or environmental causes, safety, etc.), that no leakage occurs in the joint. Flanged joints are the weak point of a pressure vessel, where this problem could happen more easily. That is why a design solution […]
Pipes are the most delicate components in any process plant, they are also the busiest entities. Piping Systems are subjected to almost all kinds of loads, intentional or unintentional. It is very important to take note of all potential loads that a piping system would encounter during operation as well as during other stages in […]
Assuming that the analysis shown in the picture is correct (which it is), the wall thickness of a piping system under internal pressure is a relationship of its internal radius, the internal pressure and the values of the axial and hoop stresses induced according to the material selected. Let’s break this down. Design Conditions An […]